Zeiss LSM 880, Operating Manual

Page: 41 / 690

CHAPTER 1 - SYSTEM OPERATION
LSM 880 Introduction to the Software Application Layout ZEISS
10/2014 V_01 000000-2071-464 35
4.5.2 Maintain
The Maintain menu from the Menu bar contains
additional modules to check and guarantee the
interference-free operation of all the software and
hardware components of the LSM 710 and LSM
780 systems. In the
Menu bar, click Maintain .
This opens the Maintain list (Fig. 22).
The maintain list is bipartite. On upper section lists
user accessible tools, the lower section lists tools
reserved for service personnel, they are password
protected.
See also section Maintain Tab for further
information.
4.5.2.1 Set Spline
This function permits calibration of the Scanner
position signals. This is required for the use of
spline curves in the
Line
scanning mode.
•
Click on
Set Spline
in the
Maintain
list.
−
The Spline window appears on the screen
(see Fig. 23).
•
You can set the required Amplitude X ,
Amplitude Y
,
Offset X
and
Offset Y
values by
using the sliders.
•
Click the
Close
button to leave the window.
Fig. 22 Maintain list
Fig. 23 Spline window