Zeiss LSM 880, Operating Manual

Page: 409 / 690

CHAPTER 1 - SYSTEM OPERATION
LSM 880 Left Tool Area and Hardware Control Tools ZEISS
10/2014 V_01 000000-2071-464 403
5.5.2.2 Select Objective
Select the Objective tab from the Objective tool,
which will show the
Name
of all objectives with an
assigned nosepiece Position . If Automatic
Component Recognition
(
ACR
) is available the
correct objective Name and Position will be
updated automatically. Otherwise you have to
proceed manually as follows after screwing the
objective into then nosepiece:
Click on the
Objective icon button of the
respective nosepiece position, which is indicated
on the nosepiece. This will open the Objective
selection menu (Fig. 563).
In the Change Objective area open one of the
available directories of Favorite Objectives (showing
all the objectives that have been previously
selected), User Defined Objectives (showing all the
objectives that have been previously defined by an
user) (Fig. 562) or Potential Objectives (showing all
objectives listed in the used ZEN database).
Expanding the field opens the respective objective
list directory (Fig. 564). An expansion triangle is
only available, when objectives are available in the
respective directory (Fig. 562). The scroll bars allow
having access to all entries in the list.
•
Select the correct objective by highlighting it.
Press the
Select Objective
button. Note that
the button becomes only active, if an objective
was selected. The Name of the objective will
appear at the corresponding position.
•
Click anywhere outside the expansi
o
n window
to close it.
Fig. 562 Objective selection
Fig. 563 Objective selection – User Defined
Objectives with empty directory
Fig. 564 Objective selection – Potential
Objectives directory