Yamaha WR450F, Owner'S Service Manual

Page: 640 / 794

5 - 51
CHAS
STEERING
9. Install:
• Plain washer
1
• Steering shaft nut
2
T
R
.
.
145 Nm (14.5 m · kg, 105 ft · lb)
10. After tightening the nut, check the steering
for smooth movement. If not, adjust the
steering by loosening the ring nut little by
little.
11. Adjust:
• Front fork top end
a
Front fork top end (standard)
a
:
Zero mm (Zero in)
12. Tighten:
• Pinch bolt (handle crown)
1
• Pinch bolt (under bracket)
2
CAUTION:
Tighten the under bracket to specified
torque. If torqued too much, it may cause
the front fork to malfunction.
13. Install:
• Multi-function meter bracket
1
• Multi-function meter
2
NOTE:
Pass the throttle cables
3
, clutch cable
4
and
hot starter cable
5
between the multi-function
meter bracket and handle crown.
14. Install:
• Holder
1
• Clamp
2
NOTE:
• Install so that the marking
a
on the speed
sensor lead aligns with the holder edge.
• Fasten the speed sensor lead to the holder
with the clamp.
T
R
.
.
21 Nm (2.1 m · kg, 15 ft · lb)
T
R
.
.
21 Nm (2.1 m · kg, 15 ft · lb)
T
R
.
.
7 Nm (0.7 m · kg, 5.1 ft · lb)
T
R
.
.
4 Nm (0.4 m · kg, 2.9 ft · lb)
T
R .
.
13 Nm (1.3 m · kg, 9.4 ft · lb)
T
R .
.
7 Nm (0.7 m · kg, 5.1 ft · lb)