Yamaha WR450F, Owner'S Service Manual

Page: 190 / 794

2 - 31
SPEC
CABLE ROUTING DIAGRAM
È
Fasten the start switch lead to the handlebar
with the plastic bands.
É
Fasten the engine stop switch lead and clutch
switch lead to the handlebar with the plastic
bands.
Ê
Pass the brake hose through the hose guides.
Ë
Secure the coupler by inserting it into the multi-
function display bracket.
Ì
Pass the throttle cables, clutch cable and hot
starter cable between the upper bracket and
multi-function display bracket.
Í
Fasten the multi-function display leads to the
bracket. Cut off the tie end.
Î
Secure the coupler by pushing it into the hole in
the multi-function display bracket.
Ï
Secure the wire harness clip by pushing it into
the hole in the multi-function display bracket on
the inside.
Ð
Fasten the main switch lead (wire harness side)
to the multi-function display bracket. Locate the
clamp end facing toward the lower side of the
frame and cut off the tie end.
Ñ
Pass the speed sensor lead through the guide
on the outside of the front fork.