Yamaha WR450F, Owner'S Service Manual

Page: 496 / 794

4 - 88
ENG
7. Install:
• Shaft
1
• Bearing
2
• Idle gear 2
3
NOTE:
Apply the engine oil on the shaft, bearing and
idle gear inner circumference.
8. Install:
• Dowel pin
• Gasket [crankcase cover (left)]
• Crankcase cover (left)
1
• Bolt [crankcase cover (left)]
NOTE:
Tighten the bolts in stage, using a crisscross
pattern.
New
T
R
.
.
10 Nm (1.0 m · kg, 7.2 ft · lb)
9. Install:
• Plain washer
• Torque limiter
1
• Plain washer
NOTE:
Apply the engine oil to the shaft and plain
washers.
1
10. Install:
• Cover (idle gear 1)
1
• Bolt
2
NOTE:
Install the cover (idle gear 1) with its mark
a
facing upward.
11. Connect:
• AC magneto lead
Refer to “CABLE ROUTING DIAGRAM”
section in the CHAPTER 2.
12. Install:
• Shift pedal
1
• Bolt (shift pedal)
NOTE:
When installing the shift pedal onto the shift
shaft, be sure that the center of the shift pedal
is about 5.1 mm (0.2 in)
a
above the top of the
footrest.
T
R
.
.
10 Nm (1.0 m · kg, 7.2 ft · lb)
T
R .
.
12 Nm (1.2 m · kg, 8.7 ft · lb)
AC MAGNETO AND STARTER CLUTCH