Welcome to the R&S
ZNA
R&S
®
ZNA
24
User Manual 1178.6462.02 ─ 20
●
Some memory traces created using "Data & Func to New Mem" (or one of the cor-
responding parser commands) were not properly loaded from recall set
●
Controlled timing (R&S
ZNA-K28):
–
It was possible to activate ALC, although ALC is not supported if controlled tim-
ing is active
–
Access to ring buffer was blocked for continuous sweeps
●
For some single-ended S-parameter measurements, "Cal Off" was displayed
although a calibration was applied
2.2
Documentation overview
This section provides an overview of the R&S
ZNA user documentation. Unless speci-
fied otherwise, you find the documents on the R&S
ZNA product page at:
https://www.rohde-schwarz.com/manual/ZNA
2.2.1
Getting started manual
Introduces the R&S
ZNA and describes how to set up and start working with the prod-
uct. Includes basic operations, typical measurement examples, and general informa-
tion, e.g. safety instructions, etc.
A printed version is delivered with the instrument. A PDF version is available for down-
load on the Internet.
2.2.2
User manual and help
The user manual contains the description of all instrument modes and functions. It also
provides an introduction to remote control, a complete description of the remote control
commands with programming examples, and information on maintenance, instrument
interfaces and error messages. Includes the contents of the getting started manual.
The contents of the user manual are available as help in the R&S
ZNA. The help offers
quick, context-sensitive access to the complete information for the instrument and its
firmware.
The user manual is also available for download or for immediate display on the Inter-
net.
2.2.3
Service manual
Describes the performance test for checking the rated specifications, module replace-
ment and repair, firmware update, troubleshooting and fault elimination, and contains
mechanical drawings and spare part lists.
Documentation overview
