GUI reference
R&S
®
ZNA
604
User Manual 1178.6462.02 ─ 20
5.12.1.4
RFFE interface configuration
Access:
Basic RFFE interface settings and command execution
The RFFE config table gives access to the channel-specific setup of the two RFFE bus
interfaces RFFE1 and RFFE2.
If at least one of the RFFE commands reads back values, an additional result area is
shown below the table. For each of these read-back commands, it displays the respec-
tive read count or, after the command was sent, the last received response (if success-
fully read).
Seq.
Enables/disables the corresponding RFFE interface in the Sweep Sequencer (see
Chapter 5.12.1.6, "Sweep Sequencer"
Remote command:
CONTrol<Ch>:RFFE<Bus>:SETTings[:STATe]
Channel Config softtool
