Concepts and features
R&S
®
ZNA
112
User Manual 1178.6462.02 ─ 20
4.2.2.3
Multi-channel setup dialog
Depending on the desired DUT and measurement type, the measurement channel has
to be prepared in a particular way. The multi-channel setup dialog was invented to
make this task as easy as possible.
Figure 4-2: Multi-channel setup dialog
The buttons in the optional "Setup" part on the right allow you to switch between differ-
ent measurement modes. The available measurement modes depend on the available
options, e.g. intermodulation measurements require option R&S
ZNA-K4 and spectrum
measurements require option R&S
ZNA-K1.
The controls in the vertical center of the dialog (to the left of the "Setup" part) allow you
to set up the selected measurement mode. From top to bottom:
●
generator and receiver ports
●
signal path (direct access, combiners etc.)
●
sweep parameters
●
measurement logic
●
measurement-specific channel settings
The channel selector in the title bar and the channel-related buttons in the lower part of
the dialog ("Copy to New Channel", "Copy to New Ch + Diagram" allow you to select
the target channels.
●
On "OK", the channel selected in the title bar of the dialog is prepared for the mea-
surement.
●
Using "Copy to New Channel" or "Copy to New Ch + Diagram" it is possible create
a channel and prepare the channel for the measurement in one go.
"OK", "Copy to New Channel" and "Copy to New Ch + Diagram" are only active, if the
configured measurement setup is valid. Error and warning messages are displayed to
point out possible configuration problems.
The info or warning icon overlayed on the "Frequency Overview" button indicates
whether the resulting source and receiver frequencies are valid. Open the related dia-
Screen elements
