R&S 1332.4500K22, User Manual

Page: 646 / 1709

GUI reference
R&S
®
ZNA
646 User Manual 1178.6462.02 ─ 20
Remote command:
CONTrol:VSE:LOCal
Scan LAN
Scans the LAN for VISA resources (VISA auto-discovery).
VISA address list
A list of known VISA adresses. populated using Scan LAN and extended manually .
If you don't want to connect to a Local VSE , mark the address of your remote target
R&S VSE as "Active" and select Start/Connect VSE / Disconnect VSE .
Remote command:
CONTrol:VSE:ADDRess
on page 1133
Set Address Manually/Apply Address
Allows you to specify the VISA address of a remote target R&S VSE manually.
"Apply Address" adds the specified address to the VISA address list . Manually added
addresses are stored in the active R&S ZNA setup.
Remote command:
CONTrol:VSE:ADDRess
on page 1133
Save VSE Configuration
If a connection to a R&S VSE instance is established, you can download its current
configuration and save it to a file on the R&S ZNA.
Remote command:
CONTrol:VSE:CONFig:SAVE
Load VSE Configuration
If a connection to a R&S VSE instance is established, you can load its configuration
from a from on the R&S ZNA (previously created using Save VSE Configuration ).
Remote command:
CONTrol:VSE:CONFig:LOAD
5.13.3 Source Coherence rab
The "Source Coherence" tab allows you to configure source signals with defined
phase.
Source coherent signals require the Phase coherent source control option R&S ZNA-
K6. If this option is not equipped, the "Source Coherence" tab is not available.
Mode softtool