Chevrolet 70 1969 Series, Shop Manual

Page: 68 / 913

CAB A N D BO D Y M O U N T IN G S 1-41
INTERIOR OF D O O R
1 Vent Window Glass
2 Division Channel
3 Access Panel
4 Remote Control Handle
5 Inside Lock Knob
6 Weatherstrip Seal Clip
and Screw
7 Weatherstrip Seal
8 Access Panel
9 Division Channel Lower
Attaching Screws
10 Escutcheon Plates
11 Regulator Handle
12 Division Channel Upper
Attaching Screws
13 Door Window
14 Sash Channel
D O O R CON STRUCTIO N
15 Door Lock Remote Control
Assembly
16 Door Lock Mechanism
17 Run Channel Retainer Screw
18 Run Channel Retainer
19 Door Window Stop Bumper
20 Window Regulator Assy.
21 Division Channel Center
Attaching Screw
t
-5/89
Figure 16— Door Construction
3. If installing door lock handle, make sure
handle is in position previously marked on door
inner panel. To install either handle, force handle
with installed lock spring over spindle until lock
spring becomes fully engaged.
D O O R LOCK A N D REMOTE CONTROL
M EC H A N ISM REPLACEMENT
N O T E : Figure 16 illustrates the position of
the lock and remote control mechanism components.
R E M O V A L (Figs. 16 and 17)
1. Remove the door inside lock knob which is
threaded on lock rod.
2. Remove the lower access panel from door
inner panel as directed previously.
3. Raise window and then remove the door in­
side handle as directed previously.
4. Remove three screws which attach the re­
mote control to door inner panel. Lower the con­
trol to door access opening, then disengage fastener
at pull-rod. Separate rod and remove control from
door.
CHEVROLET SERIES 70-80 HEAVY DUTY TRUCK SH OP MANUAL