11
■■•atfl*
wxyftfc
-W'ta-arAo! w«iij Hi
.1
MU'i lt
M.tHiWhawwas-^
POWER BRAKE 5-42
Figure 1 8 — In sta llin g U n lo a d e r A sse m b ly
half hour at 12.50 rpm , with discharge port connected to
an air tank. W ith a 1/16 - inch diam eter relief hole in dis
charge line open continuously, com pressor should m ain
tain a pressure in air tank as follows:
7 - 1/4 cu. - ft. u n i t ...............................................................75 psi
TO DECREASE SETTING
TO INCREASE SETTING
LOOSEN
LOCK NUT
T -4174
12 cu. - ft. u n i t .
.105 psi
Figure 19 — G o v e rn o r A d ju stm e n t
G O V ERN O R ADJUSTMENT
The following procedure covers adjustm ent with co m
pressor installed in test equipm ent or on vehicle. Refer to
Figure 19.
1. Loosen lock nut. Use screwdriver at adjuster plug.
2. T urn adjuster plug in (clockwise) to increase cut-out
setting, or out (counterclockwise) to decrease setting.
O ne com plete turn of adjuster screw will change cut
out pressure 20 psi.
3. W hen cut-out pressure setting of 100-107 psi is a t
tained, lock adjuster plug with lock nut.
SPECIFICATIONS
VA CU. FT. U N I T
12 CU. FT. UNIT
Compressor Model
Air-Cooled
Water-Cooled
Type.
.
..................
Capacity (at 1250 rpm)
Cylinder Bore.
Pistons
Piston Diameter at Top L a n d s....
Piston Diameter from 2nd Groove Down
Piston Pin Hole
Piston Pin Diameter
Piston Rings
Compression Ring Gap
Oil Ring Gap
Groove Clearance
Top Compression Ring
Second Compression Ring
Oil Ring
N-6400-E, N-5601-G, N-6400-G................. N-i
N-6300-N, N -6300-P...............................
, N-6000-F
N-5903-G
.2 Cylinder, Engine Lub...................... 2 Cylinder, Engine Lub.
7 Vi cu. ft. per m inute........................ 12 cu. ft. per minute
1.9995"-2.0000"..................................... 2.3745"-2.3750"
1.9945"-1.9995"
1.9945"-1.9995".
0.4995"-0.4998".
0.4998"-0.5000".
0.005"-0.010".
0.005"-0.010"
2.3685"-2.3695"
. 2.3685"-2.3695"
0.4995"-0.4998"
0.4998"-0.5000"
0.005"-0.010"
0.005"-0.010"
0.001"-0.003"..
0.001"-0.003" .
0.0010"-0.0035"
. 0.001"-0.003"
.. 0.001"-0.003"
0.0010"-0.0035"
CHEVROLET SERIES 70-80 HEAVY DUTY TRUCK SHO P M A N U A L
Summary of Contents for 70 1969 Series
