Chevrolet 70 1969 Series, Shop Manual

Page: 187 / 913

.’i l M SUSPENSION 4D-48
.* Nut
2
Y o k s
3 Dust Shield
4 Rubber Cushion
5 Cushion Retainer
6 Center Bearing Support
7 Grease Retainers
8
Siingers
9 Bearing Assembly
10 Propeller Shalt
11 Dust Shield
12 Washer
i-soii
Figure
S — Typical
Propeller'
Sh aft
Center
B e a rin g s
C A U T IO N : Use care not to permit bearings to
j.rop on floor, or irreparable damage may result,
4. Journal can now fee tilted to permit removal
of yoke r..... ' ■
il
.
5. . - / <- other two bearings in the same
manner removing journal from other
oofce.
C E N T E R BEARING D ISASSEM BLY
The following procedure covers disassembly
■ ■ if center bearing with propeller shaft removed
from vehicle. Key numbers in text refer to figure 5.
1. Remove retainer (5) from support (6), then
remove support from cushion (4).
2. Oh type shown in View A, figure 5, remove
cotter pin and nut securing yoke (2) on shaft, then
puli yoke off shaft. On type shown in View B, re­
move dust shield (11) from shaft.
3. Remove rubber cushion (4) from bearing (9),
then pull bearing assembly from shaft.
4. Remove grease retainers (7) from bearing,
and remove siingers
(
8
).
:■;;-=
1'KG ifr
3tR!fs
?o~ao HtAVv o u ry i r u c k sh o p m a n u a l