Chevrolet 70 1969 Series, Shop Manual

Page: 50 / 913

CAB A N D BODY M O U N T IN G S 1-23
PROPER TOOL-TO-CLIP E N G A G E M E N T
t
-2 5 4 8
Figure J9— Door Inside Handle Replacement
R E M O V A L
1. Remove the door inside lock knob which is
threaded on lock rod.
2. Remove the access panel from door inner
panel as directed previously under "Door Access
Panel Replacement."
3. Remove the door lock inside handle as
directed previously under "Door Inside Handles
Replacement."
4. Remove three screws which attach the re­
mote control to door inner panel. Lower the con­
trol to door access opening, then disengage fastener
at pull-rod. Separate rod from control.
5. Remove the lock cylinder assembly from
outer side of door as directed previously under
"Door Lock Cylinder Replacement."
6. At rear edge of door, remove three special
Figure 20— Door Lock Mechanism and Rods
locking-type screws which attach lock mechanism
to door frame. Lower the lock and attached two
rods out through access opening in door.
7. Separate rods from lock mechanism if de­
sired. To disengage pull-rod fastener, force lock
tab of fastener outward through small hole in lock
release lever as shown in figure 21, then slide
fastener from lever.
IN S T A L L A T IO N
Install lock mechanism with rods and remote
control in reverse of the "Removal" procedures.
IM P O R T A N T : Make sure to use the three
special locking-type screws which attach lock
mechanism to door frame.
DOOR VENT GLASS ONLY
REPLACEMENT
N O T E : This procedure covers replacement of
the vent glass only.
1. Squirt gasoline on rubber filler all around
glass frame to soften old filler. When seal softens
sufficiently, pull glass and old filler from glass
channel.
2. Thoroughly clean the inside of the glass
channel with sandpaper to remove all rust and
foreign matter.
N O T E : Ventilator glass rubber filler is sup­
plied in two thicknesses - 0.067" and 0.080" - to
permit installation in any vehicle without use of
special tools.
3. Cut new piece of glass channel rubber filler,
CHEVROLET SERIES 70 -80 H EAVY DUTY TRUCK SH O P M A N U A L