STEERING SYSTEM 9B-32
QUICK REFERENCE TROUBLE SHOOTING CHART
N O T E :
Some of the remedial procedures suggested for conditions out
lined in this chart constitute overhaul of components which is not within the
scope of this manual. Refer to “ Overhaul" section of this manual for proper
method of accomplishing these corrections.
(Type 5 5 3 -D V and 5 6 8 -D V Pow er Steering)
HYDRAULIC PUMP
C O N D IT IO N
C A U S E
R E M E D Y
1. Pum p Noise.
Loose belt.
Tighten belt.
Hoses touching otner parts of truck.
A d ju st hose position.
Low oil level.
Fill reservoir.
A ir in t ie oil.
Locate source of an leak and correct.
Excessive back p ressure caused by hoses or steer-
Locate restriction and c o r r e c t .B le e d system .
mg gear.
Sco red p ressu re plaie.
Lap aw ay light scoring. R ep lace h e a vily scored part.
V an es not installed properly.
Insta ll p roperly.
Extrem e w ea r of purnp ring.
Rep lace ring.
V an es sticking in rotor slots.
Free up by rem o ving burrs or dirt.
Face of th ru st plate scored.
Lap aw ay light scoring. Replace h e a vily scored part.
S co red rotor.
Lap aw ay light scoring. R ep lace h eavily scored part.
D etective flow control plunger.
R ep lace assem b ly.
2. Le a k s at top of
R eservo ir too full.
Fill to proper level.
of reservoir.
A ir in the oil.
Locate source of air leak and correct.
3. Le a k s at the
O-Ririg seal cut.
Rep lace 0-R ing seal.
reservo ir.
0-R ing m p ro p erly installed.
Install seal p roperly.
4. Le a k s at the
Not tightened sufficiently.
Torque to 30-40 ft.-lbs.
pressure fitting
Cross thread ed or dam aged seat.
R ep lace dam aged part.
or m ounting stud.
D efective seat on hose end.
Rep lace hose.
D am aged seals.
R ep lace seals.
5. Le a k s at the shaft
D efective seal.
R ep lace seal.
seal.
D am aged shaft.
R ep lace shaft.
6. L e a k s in m etal
Poor casting.
R ep lace d efective parts.
parts.
7. Pum p inoperative,
Loose d rive belt.
Tighten belt.
poor, or no assist.
L ow oi! level.
Fill reservoir to proper level.
A ir in the oil.
Locate source of air leak and correct.
D efective hoses or steerin g gear as d eterm ined
Correct.
by test ou tlined und er gear section later in this
chart.
Flow control v a lve stuck.
Rem ove burrs or dirt.
Loose nut in end of flow control valve.
lig h te n nut.
P re s s u re p late not flat against ring.
C orre ct condition.
Ex trem e w e a r of pum p ring.
R ep la ce pum p ring.
S co red p ressu re plate, th ru st p late, and/or rotor.
Lap aw ay light scoring. Rep lace h e a vily scored parts.
CHEVROLET SERIES 70-80 H EAVY DUTY TRUCK SH O P M A N U A L
Summary of Contents for 70 1969 Series
