Chevrolet 70 1969 Series, Shop Manual

Page: 313 / 913

ENGINE M O U N T IN G S 6D-2
Lock Nut
Mounting Spacer
Flat Washer
Upper Mounting Assy.
Lower Mounting Assy.
6 Flat Washer
7 Mounting Bolt
8 Frame Bracket
9 Engine Bracket
T-2366
figure 2—Engine front Mounting (6V-53 Engine)
IM P O R T A N T : If a lock strap or wire is used
at mounting bolts or nuts, install same to secure
the mounting.
figure I—Engine Rear Mountings IV-6
Gasoline
in Conv. Cab Models)
When replacing either rear mount it is neces­
sary to raise only that particular side of engine.
1. Before lowering engine onto new mounting
cushion, make sure cushion, bolts and bolt spacers
(if used) are positioned properly. Refer to applic­
able illustration.
N O T E : If an alignment dowel is used at mount­
ing make certain that it engages the locating hole
in mating part.
2. With cushion components in place, lower
engine just enough to allow starting of all attaching
bolts.
3. After bolts are started, lower engine to
mount, then with all components in position, tighten
the attaching bolts and nuts to torque specified in
torque chart on previous page.
(Shown with Mounting Cushions Rotated 90°)
Engine Front Cover
Support
Bolts with Flat
Washers
Mounting Bolt Nut
Flat Washer
Upper Mounting
Assembly
Lower Cushion
Mounting Bolt with
Flat Washer
Spacer
Frame Bracket or
Crossmember
T-2364
Figure 3—Engine front Mounting Assy, for V-6 Engines
CHEVROLET SERIES 70-80 H EAVY DUTY TRUCK SH O P M A N U A L