Mitsubishi Electric MELSEC-L Series, Руководство пользователя

Страница: 1033 / 1040

Appendix - 85
Appendices
Appendix 6.5 Connection with MR-JE-B
The servo amplifier MR-JE-B can be connected using SSCNET /H.
The details shown below explain about the "Connection with MR-JE-B".
[1] Comparisons of specifications with MR-J4(W)-B
[1] Comparisons of specifications with MR-J4(W)-B
Item MR-JE-B MR- J4(W)-B
Pr.100
Servo series 48: MR-JE-_B
32: MR-J4-_B_(-RJ), MR-J4W_-_B
(2-, 3- axis type)
Operation mode Standard
Standard/Fully closed/Linear/Direct
drive
Detailed
parameter 1
Pr.80
External input
signal selection
External input signals of
servo amplifier are not
available.
(Note-1)
External input signals of servo
amplifier are available.
Control loop (semi/fully) switching
command
Invalid
Valid when using servo amplifier for
fully closed loop control
Encoder resolution
131072 pulses/rev 4194304 pulses/rev
Amplifier-less operation function
Possible
(Note-2)
Possible
Driver communication Not possible Possible
Virtual servo amplifier function Not possible Possible
(Note-1): When the software version of the servo amplifier is "C4" or before:
When "1: External input signal of servo amplifier" is set in "
Pr.80 External input signal selection
" at
MR-JE-B use, the axis error or warning does not occur and the external signal (upper/lower limit
switch, near-point dog) cannot be operated. Refer to Section 14.4 "External signal selection
function" for the program example and system configuration when "2: Buffer memory of
LD77MS" is set.
(Note-2): Operates artificially as the following servo amplifier and servo motor during amplifier-less
operation mode.
Servo amplifier type: MR-J4-10B
Motor type: HG-KR053 (Resolution per servo motor rotation: 4194304 pulses)
Important
The servo amplifier MR-JE-B is integrated with the main circuit power supply and
the control power supply.
Therefore, when the power of the servo amplifier is turned OFF, the controller
cannot communicate with the axes after the axis whose power is turned OFF.