Mitsubishi Electric MELSEC-L Series, Руководство пользователя

Страница: 587 / 1040

9 - 127
Chapter 9 Major Positioning Control
9.2.20 NOP instruction
The NOP instruction is used for the nonexecutable control method.
Operation
The positioning data No. to which the NOP instruction is set transfers, without any
processing, to the operation for the next positioning data No.
Positioning data setting examples
[When "NOP instruction" is set in positioning data No.1 of axis 1]
Setting item
Setting example
Setting details
LD77MS2
LD77MS4
LD77MS16
Axis 1
Pos
itioning d
ata N
o. 1
Da.1 Operation pattern – Setting not required (Setting value is ignored.)
Da.2 Control method
NOP Set the NOP instruction
Da.3 Acceleration time No.
–
Setting not required (Setting value is ignored.)
Da.4 Deceleration time No. –
Da.5
Axis to be interpolated
LD77MS2 LD77MS4
–
Da.6
Positioning address/
movement amount
–
Da.7 Arc address –
Da.8 Command speed –
Da.9
Dwell time/JUMP
destination
positioning data No.
–
Da.10
M code/Condition
data No./Number of
LOOP to LEND
repetitions
–
Da.20
Axis to be interpolated
No.1
LD77MS16
–
Da.21
Axis to be interpolated
No.2
LD77MS16
–
Da.22
Axis to be interpolated
No.3
LD77MS16
–
(Note): Refer to Section 5.3 "List of positioning data" for information on the setting details.
Restrictions
The error "Control method setting error" (error code: 524) will occur if the "NOP
instruction" is set for the control method of the positioning data No. 600.
POINT
<Use example of NOP instruction>
If there is a possibility of speed switching or temporary stop (automatic deceleration) at a point
between two points during positioning, that data can be reserved with the NOP instruction to change
the data merely by the replacement of the identifier.