Mitsubishi Electric MELSEC-L Series, Руководство пользователя

Страница: 459 / 1040

8 - 19
Chapter 8 OPR Control
Operation timing and processing time of fast OPR
The following shows details about the operation timing and time during fast OPR.
[LD77MS4 operation example]
t1
t3
t2
Position control Standby Standby
Positioning operation
Md.26 Axis operation status
Positioning start signal
[Y10, Y11, Y12, Y13]
Start complete signal
[X10, X11, X12, X13]
BUSY signal
[XC, XD, XE, XF]
(Note): Refer to Section 3.3 for input/output signal of LD77MS16.
Fig. 8.15 Operation timing and processing time of fast OPR
Normal timing time Unit: [ms]
Operation cycle t1 t2 t3
LD77MS2
0.88 0.2 to 0.3 1.8 to 2.7 0 to 0.9
1.77 0.2 to 0.3 2.5 to 4.2 0 to 1.8
LD77MS4
0.88 0.2 to 0.3 1.8 to 2.7 0 to 0.9
1.77 0.2 to 0.3 2.5 to 4.2 0 to 1.8
LD77MS16
0.88 0.3 to 1.4 2.8 to 3.5 0 to 0.9
1.77 0.3 to 1.4 3.8 to 5.2 0 to 1.8
 The t1 timing time could be delayed by the operation state of other axes.
Operating restrictions
(1) The fast OPR can only be executed after the OP is established by executing
the Machine OPR.
If not, the error "OPR request ON" (error code: 207) will occur.
(OPR request flag (
Md.31
Status: b3
) must be turned OFF).
(2) If the fraction pulse is cleared to zero using current value changing or fixed-
feed control, execute the fast OPR and an error will occur by a cleared amount.
(3) When unlimited length feed is executed by speed control and the machine feed
value overflows or underflows once, the fast OPR cannot be executed normally.
(4) The OPR complete flag (
Md.31
Status: b4
) is not turned ON.
(5) The axis operation status during fast OPR is "in position control".