Stratasys uPrint, Service Manual, Page: 7 / 383

vii
Y EOT (End of Travel) Sensor ______________________________________________ 4-92
X Motor _________________________________________________________________ 4-93
Y Motor ________________________________________________________________ 4-100
Y Motor Belt ____________________________________________________________ 4-103
Y Drive Rod ____________________________________________________________ 4-110
XY Table _______________________________________________________________ 4-117
Z Stage Components ______________________________________________________ 4-137
Z Home Sensor _________________________________________________________ 4-137
Z EOT (End of Travel) Sensor _____________________________________________ 4-138
Chamber Fans _________________________________________________________ 4-139
Chamber Heaters ______________________________________________________ 4-141
Thermal Fuses __________________________________________________________ 4-145
Chamber Thermocouple________________________________________________ 4-148
Z Motor ________________________________________________________________ 4-149
Z Stage ________________________________________________________________ 4-153
Calibrations & Adjustments ___________________________________ 5-1
Offset Calibrations ___________________________________________________________ 5-2
Adjusting Z Calibration and XY Tip Offset ___________________________________ 5-2
Z Calibration__________________________________________________________ 5-2
XY Tip Calibration_________________________________________________________ 5-5
Part Based Calibration ____________________________________________________ 5-7
When to Perform Part Based calibration ________________________________ 5-7
Tensioning the X & Y Drive Belts ______________________________________________ 5-37
Get/Send Calibration Files ___________________________________________________ 5-41
Get/Send calibration files ____________________________________________ 5-41
XY Table Leveling ___________________________________________________________ 5-43
Head Alignment Procedure__________________________________________________ 5-47
Troubleshooting ______________________________________________ 6-1
User Troubleshooting _________________________________________________________ 6-2
Fault determination codes ________________________________________________ 6-3
Exporting printer configuration (.cfg) file ___________________________________ 6-4
Cycling power ___________________________________________________________ 6-4
Diagnosing loss of extrusion _______________________________________________ 6-4
Clogged tip ______________________________________________________________ 6-5
Material Jam _____________________________________________________________ 6-6
Recovering from loss of extrusion __________________________________________ 6-8
Service Troubleshooting _____________________________________________________ 6-12
1.0 How to use this Guide ________________________________________________ 6-12
2.0 Code Errors __________________________________________________________ 6-13
Major Codes ________________________________________________________ 6-13
Major Codes with Minor Codes _______________________________________ 6-14
Controller Abort Minor Errors (Code: 14, XX)____________________________ 6-14
Starting Up Failed Minor Errors (15.XX) _________________________________ 6-22
Controller Load Failed Minor Errors (17.XX) _____________________________ 6-22
Temperature Failed to Regulate Minor Errors (18.XX) ___________________ 6-23