Stratasys uPrint, Service Manual, Page: 149 / 383

4-102
Figure 4-174: Y motor mounting screw locations
8.
Remove the Y motor.
Installing the Y motor
1.
Align the Y motor with the Y motor mounting bracket, making sure the Y motor cable
faces the back of the printer.
2.
Using a
9
⁄
64
” allen wrench, reinstall the 4 Y motor mounting screws.
3.
Align the Y motor mounting bracket with mounting holes.
4.
Using a
5
⁄
16
” nut driver or standard screwdriver, loosely reinstall the Y motor mounting
bracket mounting screws.
5.
Place the Y motor belt around the Y motor pulley.
6.
Slide the Y motor mounting bracket up until the Y belt is tight.
7.
Using a
5
⁄
16
” nut driver or standard screwdriver, securely fasten the Y motor mounting
bracket mounting screws.
8.
Reconnect the Y motor cable.
9.
Align the left side access panel with the mounting holes.
10.
Using a
5
⁄
16
” nut driver or standard screwdriver, reinstall the left side access panel
mounting screws.
11.
Reinstall the upper electronics bay cover. See Installing the upper electronics bay cover
on page 4-18.
12.
Reinstall the side panels. See Installing the side panels on page 4-8.
13.
Reinstall the top panel. See Installing the top panel on page 4-6.
Remove the 4
mounting screws