Stratasys uPrint, Service Manual, Page: 217 / 383

5-8
8.
Locate the filled circle, this indicates the front of the substrate, see Figure 5-282.
Figure 5-282: Locating the Filled Circle (B)
9.
Using a digital caliper, measure and record the diameter of circle B along the center line
between A and C, see Figure 5-283.
Figure 5-283: Measuring diameter of B
10.
Next measure and record the distance from the outside edges of circle A and B, see
Figure 5-284. Ensure that the caliper is not seated on the small bump of circle A.
Note: Reference letters are not actually “printed” on the part. If needed, use the
Part Measurement Equations sheet to record the values. See Part Measurement
Equations on page 5-21.