Stratasys uPrint, Service Manual, Page: 100 / 383

uPrint/uPrint SE Service Manual 4-53
Figure 4-87: Power input cable location
10.
Using a Phillips screwdriver, remove the 3 mounting screws. See Figure 4-88.
Figure 4-88: 5/12 VDC supply mounting screw locations
11.
Remove the 5/12VDC power supply.
Installing the 5/12VDC power supply
1.
Align the 5/12VDC power supply and press down into place.
2.
Using a Phillips screwdriver, reinstall the 3 mounting screws.
3.
Reconnect the SK2 connector.
4.
Reconnect the J2 spade connector.
5.
Close the rear panel of the electronics bay.
6.
Using a
5
⁄
16
” nut driver or standard screwdriver, reinstall the 3 rear electronics bay
mounting screws.
7.
Reinstall the electronics bay. See Installing the electronics bay on page 4-20.
8.
Reinstall the side panels. See Installing the side panels on page 4-8.
9.
Reinstall the top panel. See Installing the top panel on page 4-6.