Stratasys uPrint, Service Manual, Page: 139 / 383

4-92
Y EOT (End of Travel) Sensor
Required Tools
•
1
⁄
4
” nut driver or standard screwdriver.
Hardware
• 6-32 x
3
⁄
8
” slotted screw (x1)
Removing the Y EOT sensor
1.
Remove the top panel. See Removing the top panel on page 4-5.
2.
Disconnect the Y EOT cable by pressing in on the tab and pulling outward. See Figure 4-
156.
Figure 4-156: Y EOT sensor cable location
3.
Using a
1
⁄
4
” nut driver or standard screwdriver, remove the mounting screw. See Figure
4-157.
Figure 4-157: Y EOT sensor mounting screw location
4.
Remove the Y EOT sensor.
Installing the Y EOT Sensor
1.
Align the Y EOT Sensor with the mounting hole.
2.
Using a
1
⁄
4
” nut driver or standard screwdriver, reinstall the mounting screw.
3.
Reconnect the Y EOT cable.
4.
Install the top panel. See Installing the top panel on page 4-6.
Disconnect the
Y EOT cable
Remove the
mounting screw