Stratasys uPrint, Service Manual, Page: 109 / 383

4-62
Figure 4-103: Wire tie location
12.
Disconnect the 3 cables from the rear of the head board by pressing the tabs in and
pulling outward. See Figure 4-104.
Figure 4-104: Rear head board cable locations
13.
Using a
5
⁄
16
” nut driver or standard screwdriver, remove the 4 toggle head mounting
screws. Toggle the head to the left to remove the bottom right screw and toggle the head
to the right to remove the bottom left screw. See Figure 4-105.
Figure 4-105: Toggle head mounting screw locations
14.
Slide the toggle head assembly out of the translator.
Cut and remove
the wire tie from
the head motor
Disconnect the
3 cables
Remove the
toggle
head
mounting
screws
Remove
the toggle
head
mounting
screws