Stratasys uPrint, Service Manual, Page: 128 / 383

uPrint/uPrint SE Service Manual 4-81
Installing the head board
1.
Align the head board with the mounting holes.
2.
Using a
1
⁄
4
” nut driver or standard screwdriver, reinstall the 4 mounting screws.
3.
Reconnect the substrate sensor cable and the 2 filament motor cables to the rear of the
head board.
4.
Feed the toggle sensor cable through the head board.
5.
Using a
1
⁄
4
” nut driver or standard screwdriver, reinstall the toggle sensor wire clips.
6.
Reconnect the toggle sensor cable to the toggle sensor.
7.
Reconnect the toggle sensor cable to the head board.
8.
Reconnect the model and support heater cables.
9.
Reconnect the umbilical cable.
10.
Place the thermocouple wires in the wire retaining clip.
11.
Reconnect the model and support material tubes.
12.
Reinstall the air plenum.
13.
Reinstall the head cover.
14.
Reinstall the right side access cover.
15.
Reinstall the side panels. See Installing the side panels on page 4-8.
16.
Reinstall the top panel. See Installing the top panel on page 4-6.