Stratasys uPrint, Service Manual, Page: 39 / 383

3-4
DataStatEX
DataStatEX is a “condensed” version of MaracaEX. It was developed to:
• Aid in troubleshooting system problems by allowing the customer to view and report
specific system information.
• Allow the customer to adjust Z Tip to Tip (difference in tip heights)
• Replacement toggle heads will be shipped with a factory Z Tip to Tip value. One the
head is installed the customer must enter this value using DataStatEX. Service
providers may also use MaracaEX to enter this value.
Using DataStatEX allows you to:
• Select a modeler.
• Add or delete a modeler.
• View a detailed system status window. The window includes important output
“state” information. This information will aid in troubleshooting system problems
without being on-site.
• View detailed material information.
• Adjust Z Tip to Tip.
• Reset the administrator password to null.
DataStatEX is located as a separate program on all system CD’s. DataStatEX will NOT install
on the workstation when performing a backend download. DataStatEX is used primarily for
diagnosing system problems. Generally the customer does not need to access DataStatEX.
For this reason, the customer should only use DataStatEX when requested by a trained
service representative.
Parts and Tools Required
• System CD
• Workstation
Procedure
1.
Insert the system CD into workstation.
2.
Select the CD drive and open the DataStatEX folder.
3.
Select setup.exe .
4.
Follow the install steps displayed to load the program on the workstation.
5.
Open DataStatEX from Start – Programs pull down.
6.
Select the “+” button and enter the system name, type and IP address. Do not enter
leading 0’s in the IP address.
7.
Select the green arrow to close the window.
8.
Select the “connect to modeler” (two blue arrows) button to establish communications to
the system.
9.
Information is now shown in the Current Modeler and State windows of DataStatEX.
10.
From this point the customer can open any of the button options.