Stratasys uPrint, Service Manual, Page: 75 / 383

4-28
8.
Using a standard screwdriver, loosen the display cable mounting screws. See Figure 4-
50.
9.
Disconnect the display cable from the SBC. See Figure 4-50.
Figure 4-50: SBC display cable location
Installing the single board computer
1.
Reconnect the display cable.
2.
Using a standard screwdriver, tighten the display cable mounting screws.
3.
Reconnect the IDE ribbon cable.
4.
Align the SBC with the mounting holes.
5.
Using a Phillips screwdriver, reinstall the 4 mounting screws.
6.
Reconnect the RJ-45 network cable.
7.
Reconnect the J2 power cable.
8.
Reinstall the controller board. See Installing the controller board on page 4-25.
9.
Close the electronics bay. See Closing the electronics bay on page 4-16.
Disconnect the
Display cable