Stratasys uPrint, Service Manual, Page: 289 / 383

6-22
44.
Starting Up Failed Minor Errors (15.XX)
45.
Controller Load Failed Minor Errors (17.XX)
46.
47.
14,144 Support filament not present
at EOF switch.
Currently unused.
Software use only.
14,145 Model filament not present at
FP switch.
Currently unused.
Software use only.
14,146 Support filament not present
at FP switch.
Currently unused.
Software use only.
Code Description Corrective Actions
15,01 Startup state activation failed
15,02 Time-out period expired while
starting up
Software use only
1. See CFG file for additional error details.
2. Replacement Controller or Hard Drive is gendered incorrectly.
3. If printer is in Dynamic Mode:
a. Issue may be a network timeout due to improper DHCP settings on
the network. Verify by looking at CFG, if code reads:
- MASTER logger: Punching nameserver xxx.xxx.xxx.xxx through
the firewall.
b. If using System Software version 2230 try workaround. Contact CS
for workaround instructions.
c. Upgrade System Software to a version newer than 2230.
4. Material Bay Connection time-out. Refer to error code 14,139.
Code Description Corrective Actions
17,01 LG_COMMAND Failed on
Controller
Software use only.
17,02 LG_COMMAND Time-out
Software use only.
Code Description Corrective Actions