Stratasys uPrint, Service Manual, Page: 125 / 383

4-78
Figure 4-130: Retaining clip location
8.
Disconnect the umbilical cable by pressing in on the tab and pulling upwards. See Figure
4-131.
Figure 4-131: Umbilical cable location
9.
Disconnect the model and support heater cables by pressing in on the tabs and pulling
outward. See Figure 4-132.
Figure 4-132: Model and support heater cable locations
10.
Disconnect the toggle sensor cable from the head board by pressing in on the tab and
pulling outward. See Figure 4-133.
Remove the
thermocouple
wires from the
retaining clip
Disconnect
the umbilical
cable
Disconnect the
support side
heater cable
Disconnect the
model side
heater cable