Stratasys uPrint, Service Manual, Page: 266 / 383

uPrint/uPrint SE Service Manual 5-57
Figure 5-376: Liquefier alignment check (2 of 2)
Complete the Re-Assembly of the Toggle Head Assembly
1.
Connect the Filament Tubes to the top of the Toggle Head Assembly - make sure the
model tube is on the right; the support tube on the left.
2.
Install the Air Plenum - connect the Plenum to the air duct at top - press in on clips to fit
the plenum to the Translator.
3.
Install the Head Cover - squeeze the side tabs to fit the Translator.
4.
Power the printer up.
5.
From the display panel, press Maintenance > System > Tips and perform the following
calibrations:
A.
Z calibration. See Z Calibration on page 5-2.
B.
XY Tip offset calibration. See XY Tip Calibration on page 5-5.
Note: Follow the Head Installation Checklist after completing Toggle Plate
Assembly replacement.
Unacceptable
liquefier alignment
Pinch point is the
same as the
centerline of the
alignment rod.