Stratasys uPrint, Service Manual, Page: 51 / 383

4-4
Required Tools list
Distributer/Reseller supplied Tools
1.
Standard screwdriver set
2.
Phillips screwdriver set
3.
Allen wrench set
4.
Pliers
5.
Channel locks
6.
Small wire cutters
7.
Needle nose pliers
8.
Assorted wire ties
9.
Box wrenches
10.
Flashlight
11.
Grounding strap
12.
Voltmeter
13.
Network crossover cable (for communication testing)
14.
Laptop computer
15.
Nut driver set
16.
Dial indicator
17.
Serial data cable (for issuing TeraTerm commands)
Supplied by Stratasys
1.
Belt tension gauge (for adjusting XY table drive belts)
2.
Y-Motor belt tensioning tool (for adjusting belt Y table motor belt)
3.
Head dial indicator bracket (for XY table and Z stage leveling)
4.
Spring Removal Tool
5.
Drive Wheel Alignment Rod
6.
Set of Shims (Feeler Gauges)
7.
Liquefier Alignment Rod
8.
Filament Guide Alignment Rod (For SST Only)
9.
Service Guide (CD and Hardcopy)
10.
MaracaEX CD
11.
CatalystEX CD
12.
Controller software CD
Pre-Maintenance Procedures
1.
Unload model and support material.
2.
Power the printer down using the power switch.
3.
After the printer has powered down, turn the main power toggle switch off on the back
of the unit.
4.
Remove the AC power cord, RJ-45 network cable and UPS cable (if used) from the back
of the unit.