Stratasys uPrint, Service Manual, Page: 156 / 383

uPrint/uPrint SE Service Manual 4-109
Installing the Y Motor Belt
1.
Slide the Y motor belt over the Y drive rod.
2.
Align Y drive rod with the 6 mounting holes.
3.
Using a
5
⁄
16
” nut driver or standard screwdriver, reinstall the 6 Y drive rod mounting
screws.
4.
Place the Y motor belt around the Y motor pulley.
5.
Lift the Y motor until the Y belt is tight and use a
5
⁄
16
” nut driver or standard screwdriver
to tighten the 4 Y motor mounting bracket mounting screws.
6.
Align the foam insert over the mounting brackets.
7.
Using a
5
⁄
16
” nut driver or standard screwdriver reinstall the 4 foam retaining screws and
washers.
8.
Align the head cooling fan mounting bracket and Use a
5
⁄
16
” nut driver or standard
screwdriver to reinstall the 2 mounting bracket screws.
9.
Reconnect the head cooling fan.
10.
Using a
5
⁄
16
” nut driver or standard screwdriver reinstall the left side access panel.
11.
Using a
5
⁄
16
” nut driver or standard screwdriver reinstall the right side access panel.
12.
Reinstall the Electronics Bay. See Installing the electronics bay on page 4-20.
13.
Reinstall the upper electronics bay cover. See Installing the upper electronics bay cover
on page 4-18.
14.
Place the left and right Y belts into the retaining clips. Do not tighten the retaining clips at
this time.
15.
Tension the Y belts. See Checking/Adjusting the Y-Drive Belt Tension on page 5-39.
16.
Reinstall the left and right side access panels.
17.
Reinstall the front panel. See Installing the front panel on page 4-12.
18.
Reinstall the Side panels. See Installing the side panels on page 4-8.
19.
Reinstall the top panel. See Installing the top panel on page 4-6.
20.
Reconnect the material bay cable, network cable and power cable.