Stratasys uPrint, Service Manual, Page: 248 / 383

uPrint/uPrint SE Service Manual 5-39
Figure 5-356: X-Drive Belt Tension Adjustment
7.
Remove the belt fixture and run the head back and forth several times.
8.
Continue to adjust and check the tension until the tension meets specification.
9.
Reinstall side and top panels.
Checking/Adjusting the Y-Drive Belt Tension
1.
Remove the top, side and side access panels.
2.
If required, allow system to cool to room temperature (approximately 20 minutes).
3.
Move the Head Assembly to full rear travel within the build envelope
4.
Position the dial indicator on the top section of the Y-Drive belt at the center point of the
belt. See Figure 5-357.
Figure 5-357: Y-Drive Belt Tension Check
Note: The Y-Drive system consists of two drive belts - one on each side of the
build envelope. Each belt must be checked, adjusted and of equal values.
X belt tension
bolt
Dial Indicator position for Y-Drive belt tension check. Y-Drive Belt clamp (one on each side).