Stratasys uPrint, Service Manual, Page: 67 / 383

4-20
Figure 4-38: Electronics Bay mounting screw locations
8.
Slide the electronics bay out 3 inches (76mm) and disconnect the cables from the rear of
the power distribution board. See Figure 4-39.
Figure 4-39: Power Distribution Board rear cable locations
9.
To remove, slide the entire electronics bay out from the back of the printer.
Installing the electronics bay
1.
Slide the electronics bay into position, leaving 3 inches (76mm).
2.
Connect the 4 rear power distribution board cables.
3.
Slide the electronics bay back into position
4.
Using a
5
⁄
16
” nut driver or standard screwdriver, reinstall the 4 left and 4 right side
mounting screws.
5.
Connect the I/O card cables.
6.
Reinstall the upper electronics bay cover. See Installing the upper electronics bay cover
on page 4-18.
7.
Reinstall the side panels. See Installing the side panels on page 4-8.
8.
Reinstall the top panel. See Installing the top panel on page 4-6.
Remove the 4 right
side mounting screws
Remove the 4 left side
mounting screws
PDB rear cable locations