Stratasys uPrint, Service Manual, Page: 202 / 383

uPrint/uPrint SE Service Manual 4-155
Figure 4-267: Upper Z stage guide rod mounting screw locations
8.
Remove the Z stage by pulling out of the printer through the chamber door.
Installing the Z stage
1.
Align the Z stage guide rods with the upper and lower mounting holes.
2.
Using a
5
⁄
16
” socket driver or
5
⁄
16
” box wrench, loosely fasten the lower Z stage guide rod
mounting screws.
3.
Using a 5/6” nut driver or standard screwdriver, loosely fasten the upper Z stage guide
rod mounting screws.
4.
Using a
3
⁄
32
” allen wrench, Reinstall the 4 Z motor energy chain mounting screws.
5.
Move Z stage to the middle of travel.
6.
Place one Z stage guide rod alignment fixture at the bottom of the Z stage. See Figure 4-
268.
7.
Place one Z stage guide rod alignment fixture at the top of the Z stage, See Figure 4-268.
Figure 4-268: Z stage guide rod alignment fixture locations
8.
Using a
5
⁄
16
” socket driver or
5
⁄
16
” box wrench, securely fasten the lower Z stage guide
rod mounting screws.
Remove the 2
mounting screws
Z Stage guide rod
alignment fixtures