Stratasys uPrint, Service Manual, Page: 96 / 383

uPrint/uPrint SE Service Manual 4-49
Figure 4-79: J1 cable location
8.
Disconnect J3 1 through 4 connectors using a Phillips screwdriver. Note the position of
the wires for reinstallation. See Figure 4-80.
Figure 4-80: J3 1 through 4 connector locations
9.
Close the rear panel of the electronics bay and remove the 2 board mounting screws
using a Phillips screwdriver. See Figure 4-81.
Figure 4-81: Closing the rear panel of the electronics bay
10.
Open the rear panel of the electronics bay and remove the 2 board mounting screws from
the top of the panel using a Phillips screwdriver. See Figure 4-82.
Disconnect J1
Disconnect J3
1 through 4
Remove the 2
mounting screws