Stratasys uPrint, Service Manual, Page: 102 / 383

uPrint/uPrint SE Service Manual 4-55
Figure 4-90: J601 connector location
8.
Using a Phillips screwdriver, remove the 3 mounting screws. See Figure 4-91.
Figure 4-91: 120 VDC mounting screw locations
9.
Remove the 120VDC power supply.
Installing the 120 VDC power supply
1.
Align the 120VDC power supply with the mounting holes.
2.
Using a Phillips screwdriver, reinstall the 3 mounting screws.
3.
Reconnect J601.
4.
Close the rear panel of the electronics bay.
5.
Using a
5
⁄
16
” nut driver or standard screwdriver, reinstall the 3 rear electronics bay
mounting screws.
6.
Reinstall the electronics bay. See Installing the electronics bay on page 4-20.
7.
Reinstall the side panels. See Installing the side panels on page 4-8.
8.
Reinstall the top panel. See Installing the top panel on page 4-6.
Disconnect
J601