Stratasys uPrint, Service Manual, Page: 195 / 383

4-148
Chamber Thermocouple
Required Tools
•
5
⁄
16
” nut driver.
• standard screwdriver.
Removing the chamber thermocouple
1.
Remove the top panel. See Removing the top panel on page 4-5.
2.
Remove the side panels. See Side Panels on page 4-7.
3.
Remove the upper electronics bay cover. See Removing the upper electronics bay cover
on page 4-17.
4.
Remove the electronics bay. See Removing the electronics bay on page 4-19.
5.
Push the strain relief clip out towards the front of the printer using a small standard
screwdriver. See Figure 4-258.
Figure 4-258: Strain relief clip location
6.
Bend the tip of the thermocouple straight and slide out through the strain relief clip.
7.
Remove the thermocouple.
Installing the chamber thermocouple
1.
Push the thermocouple through the mounting hole until it is 3/4” (19mm) through the
other side.
2.
Push the strain relief in to lock the thermocouple in place.
3.
Bend the thermocouple over to the left. See Figure 4-259.
Figure 4-259: Bending the thermocouple
4. Reinstall the electronics bay. See Installing the electronics bay on page 4-20.
5. Reinstall the upper electronics bay cover. See Installing the upper electronics bay cover
on page 4-18.
6. Reinstall the side panels. See Installing the side panels on page 4-8.
7. Reinstall the top panel. See Installing the top panel on page 4-6.
Push the strain relief
tab towards the front
of the printer to
remove.