Stratasys uPrint, Service Manual, Page: 107 / 383

4-60
Figure 4-97: Material tubes and retaining rings
7.
Disconnect the thermocouples from the TC Amp board and remove the wires from the
wire retainer. See Figure 4-98 and Figure 4-99.
Figure 4-98: Thermocouple locations
Figure 4-99: Thermocouple wire retainer location
8.
Disconnect the model and support heater cables by pressing the tabs in and pulling the
cables outward. See Figure 4-100.
Press down
on the
retaining
rings
Lift the
material
tubes out of
the rings
Disconnect the 2
thermocouples
from the TC Amp
board
Remove the
thermocouple
wires from the
retainer