Stratasys uPrint, Service Manual, Page: 124 / 383

uPrint/uPrint SE Service Manual 4-77
Figure 4-127: Head cover tab locations
5.
Remove the air plenum by pressing in the upper and lower tabs and pulling outward.
See Figure 4-128.
Figure 4-128: Air plenum tab locations
6.
Disconnect the model and support material tubes. See Figure 4-129.
Figure 4-129: Material tube and retaining ring locations
7.
Remove the thermocouple wires from the wire retaining clip on the head board. See
Figure 4-130.
Press tab in to
release head
cover
Press tab in to
release head
cover
Press in tab to
release air
plenum
Press in tab to
release air
plenum
Press in tab to
release air
plenum
Press in tab to
release air
plenum
Press down on
the retaining
rings
Lift the
material
tubes out
of the rings