Stratasys uPrint, Service Manual, Page: 256 / 383

uPrint/uPrint SE Service Manual 5-47
Head Alignment Procedure
Figure 5-364: Special Head Alignment Tools
Drive Wheel Alignment
This procedure axially aligns the Head Motor Drive Wheel with the filament path.
1.
Remove the Pivot Block Spring using spring removal tool. See Figure 5-365.
Figure 5-365: Pivot block spring location
2.
Remove the right side Pivot Block.
• Remove the retaining clip and teflon washer from the right side Pivot Block Pin.
3.
Move the Toggle Bar to the right.
Note: This procedure must be accomplished in its entirety and in the order
presented. The procedure consists of 2 procedures: Idler Wheel Adjustment and
Liquefier Alignment.
Spring removal tool
Drive wheel
alignment rod Liquifier
alignment rod
Shim set
Spring removal tool Spring removal tool
Drive wheel
alignment rod Drive wheel
alignment rod Liquifier
alignment rod Liquifier
alignment rod
Shim set Shim set
Pivot Block Spring
Tool