Stratasys uPrint, Service Manual, Page: 134 / 383

uPrint/uPrint SE Service Manual 4-87
Installing the umbilical hose
1.
Feed the umbilical hose through the energy chain.
2.
Align the energy chain with the mounting holes.
3.
Using a
5
⁄
32
” allen wrench, reinstall the energy chain mounting screws.
4.
Reinstall a wire tie around the umbilical hose. See Figure 4-150.
Figure 4-150: Umbilical hose wire tie location
5.
Reconnect the model and support material tubes.
6.
Reinstall the air plenum.
7.
Reinstall the head cover.
8.
Reconnect the umbilical hose to the head cooling fan.
9.
Using a
1
⁄
4
” nut driver or standard screwdriver, tighten the umbilical hose clamp.
10.
Align the right side access panel with the mounting holes.
11.
Using a
5
⁄
16
” nut driver or standard screwdriver, reinstall the right side access panel
mounting screws.
12.
Reinstall the upper electronics bay cover. See Installing the upper electronics bay cover
on page 4-18.
13.
Reinstall the side panels. See Installing the side panels on page 4-8.
14.
Reinstall the top panel. See Installing the top panel on page 4-6.
Reinstall the
wire tie