Stratasys uPrint, Service Manual, Page: 86 / 383

uPrint/uPrint SE Service Manual 4-39
Installing the IDE hard drive
1.
Using a Phillips screwdriver, reinstall the 2 mounting brackets.
2.
Push the hard drive in the slots and down into position.
3.
Using a Phillips screwdriver, reinstall the 4 mounting screws.
4.
Reconnect the SATA cable.
5.
Reconnect the power input cable.
6.
Close the electronics bay. See Closing the electronics bay on page 4-16.
7.
Power up the printer. The printer may take up to 45 minutes to run the Check Disc
command before you see anything on the display panel.
8.
After the printer has rebooted and is idle, press
Maintenance > System > Set Network.
9.
Select either Dynamic networking or Static networking.
10.
If using Static networking, enter the printers IP Address, Default Gateway and Subnet
Mask values.
11.
From the PC, open the CatalystEX.
12.
Connect to the printer.
13.
Insert the printer firmware CD into the workstation CD drive.
14.
From the Printer Services tab, click on the Update Software button.
15.
Navigate CatalystEX to the Upgrade (.UPG) file on the printer firmware CD.
16.
The printer will load, reboot and verify the upgrade.
17.
If the printer has System Software version 9.0 build 3230 or newer installation is
complete. If the printer System Software is older than version 9.0 build 3230, complete
the following steps:
A.
Remove the printer calibration CD from the electronics bay and insert into the
workstation CD drive.
B.
Install and open MaracaEX. Ensure that communications has been established
with the printer.
C.
Select “Send” and browse to the CD drive.
D.
Select the xxx.cal (where xxx equals printer name) from the CD by double clicking
on the file name.
E.
To complete sending the file, click on the green check mark. This will write the
file to the printer hard drive.
F.
Cycle power on the printer.
G.
Replace the CD into the electronics bay.
H.
Perform Offset calibrations, see Offset Calibrations on page 5-2.
I.
Perform Part Based calibration, see Part Based Calibration on page 5-7.