Stratasys uPrint, Service Manual, Page: 172 / 383

uPrint/uPrint SE Service Manual 4-125
Figure 4-220: Y-Drive Belt Tension Check
6.
The gauge should read between 0.425 and 0.435 mils. See Figure 4-221.
Figure 4-221: Gauge readings
7.
If the tension is not within specification, locate the Y belt tension adjustment nut on the
front of the system. See Figure 4-220.
8.
Adjust (increase/decrease) the tension by turning the tensioning nut ( Figure 4-222. ) so
that the dial indicator reads between 0.425 and 0.435 mils.
Figure 4-222: Y drive belt tension adjustment
Dial Indicator position for
Y-Drive belt tension check.
Y-Drive Belt clamp
(one on each side).
Service Limit
Adjustment Limit
Y-Drive Belt
Tension
Adjusting Nut