Stratasys uPrint, Service Manual, Page: 219 / 383

5-10
Figure 5-288: Measuring diameter of circle F
16.
Add the lengths derived from steps 14 and 15 (E-F and F-G) and then subtract the width
of circle F derived from step 16. Record this total as “GRear”
17.
Measure and record the distance from the outside edges of circles C and G. Ensure the
caliper is not seated on the small bump of circles C or G. Record this total as “GRight”,
see Figure 5-289.
Figure 5-289: Measuring distances from outside edges of C and G
18.
Measure and record the distance from the outside edges of circles A and E. Ensure the
caliper is not seated on the small bump of circles A or E. Record this total as “GLeft”, see
Figure 5-290.