Stratasys uPrint, Service Manual, Page: 117 / 383

4-70
5.
Using a standard screwdriver, remove the 2 toggle sensor mounting screws. See Figure
4-116.
Figure 4-116: Toggle sensor mounting screw locations
6.
Remove the toggle sensor.
Installing the toggle sensor
1.
Align the toggle sensor with the mounting holes.
2.
Using a standard screwdriver, reinstall the 2 mounting screws.
3.
Reconnect the toggle sensor wire to the toggle sensor.
4.
Align the right side access panel with the mounting holes.
5.
Using a
5
⁄
16
” nut driver or standard screwdriver, reinstall the right side access panel
mounting screws.
6.
Reinstall the side panels. See Installing the side panels on page 4-8.
7.
Reinstall the top panel. See Installing the top panel on page 4-6.
Remove the 2
mounting screws