Stratasys uPrint, Service Manual, Page: 355 / 383

7-12
6.
Verify the tip is fully inserted into the heater block and that the stainless steel shield is
aligned. See Figure 7-413.
7.
Use 7/64 T-Handle Allen wrench to firmly tighten the heater block clamp screws. See
Figure 7-413.
Figure 7-413: Installation Examples
8.
Repeat steps 3 through 7 for the other tip if necessary.
9.
Install a new tip shield by pushing it over the exposed tip, keeping the slotted end
toward the back of the head. See Figure 7-414.
Figure 7-414: Tip shield installation
Note: Make sure the tip remains all the way up against the heater block as you
tighten the screws.
Note: Tip shield should be flush with the tip plate as shown in Figure 7-415.
INCORRECT -
Shield
interference
INCORRECT -
Tip not seated
CORRECT