Stratasys uPrint, Service Manual, Page: 95 / 383

4-48
24VDC Power Supply
Required Tools
•
5
⁄
16
” nut driver or standard screwdriver.
• Phillips screwdriver
Hardware
• 10-32 x
3
⁄
8
” slotted screws (x3)
• 6-32 x
1
⁄
4
” Phillips pan head screws (x2)
Removing the 24VDC Power Supply
1.
Remove the top panel. See Removing the top panel on page 4-5.
2.
Remove the side panels. See Side Panels on page 4-7.
3.
Remove the electronics bay. See Removing the electronics bay on page 4-19.
4.
Using a
5
⁄
16
” nut driver or standard screwdriver, remove the 3 rear electronics bay
mounting screws. See Figure 4-78.
Figure 4-78: Rear electronics bay mounting screw locations
5.
Open the rear panel of the electronics bay.
6.
Touch the metal plate of the electronics bay cover to discharge any static electricity.
7.
Disconnect the J1 connector on the 24VDC power supply. See Figure 4-79.
Remove the 3
mounting screws