Stratasys uPrint, Service Manual, Page: 151 / 383

4-104
5.
Disconnect the material bay cable from the printer.
6.
Remove the Front Panel. See Removing the front panel on page 4-11.
7.
Remove the Electronics Bay. See Removing the electronics bay on page 4-19.
8.
Using a
5
⁄
16
” nut driver or standard screwdriver, remove the right side access panel
mounting screws and remove the right side access panel. See Figure 4-176.
Figure 4-176: Right side access panel mounting screw locations
9.
Using a
5
⁄
16
” box wrench, remove the outer Y belt retaining clip mounting screws from
the left side. See Figure 4-177.
10.
Using a
5
⁄
16
” box wrench, loosen, but do not remove, the inner Y belt retaining clip
mounting screws from the left side. See Figure 4-177.
11.
Pull the left side Y belt out from the retaining clip.
Figure 4-177: Left side Y belt retaining clip mounting screw locations
12.
Using a
5
⁄
16
” box wrench, remove the outer Y belt retaining clip mounting screws from
the right side. See Figure 4-178.
13.
Using a
5
⁄
16
” box wrench, loosen, but do not remove, the inner Y belt retaining clip
mounting screws from the right side. See Figure 4-178.
14.
Pull the right side Y belt out from the retaining clip.
Remove the 7
mounting
screws.
Remove the outer
mounting screws
Loosen, but do not
remove the inner
mounting screws