Stratasys uPrint, Service Manual, Page: 127 / 383

4-80
Figure 4-136: Removing the toggle sensor cable from the head board
14.
Disconnect the substrate sensor cable and filament motor cables from the rear of the head
board by pressing the tabs in and pulling outward. See Figure 4-137.
Figure 4-137: Rear head board cable locations
15.
Using a
1
⁄
4
” nut driver or standard screwdriver, remove the 4 head board mounting
screws. See Figure 4-138.
Figure 4-138: Remove the head board mounting screws
Feed toggle sensor
cable through the
head board
Disconnect the
3 cables
Remove the head
board mounting screws